Nexcom VTC 6100 User Manual download pdf (Page 64)

VTC 6100 User Manual

Chapter 3: System Setup

Installing a SATA Hard Drive

1. The metal bracket is used to hold a SATA hard drive. First, remove the

screws that secure the metal bracket to the board then remove the

bracket.

If you intend to install a CompactFlash card or a Mini PCI Express

module, please install these devices first before proceeding to the

next step. Refer to their respective sections in this chapter for in-

structions on installing a CF card or a Mini PCI Express module.

2. Position the HDD brackets on each side of the SATA drive. Align the

mounting holes that are on the sides of the SATA drive with the HDD

brackets’ mounting screws.

HDD bracket

SATA drive

Mounting

screws

Metal

bracket

Mounting

screws

• During Windows XP OS installation, press “F6” to select and

install the SATA driver.

• If you intend to install a Windows XP SP2 or earlier version, you

must first set the “USB 2.0 Controller” field (in the BIOS) to

Disabled.

• By default, the “Legacy USB Support” field (in the BIOS) is

Disabled. If you are using a USB device to install the Windows

operating system, you must first set this field to Enabled. Set this

field back to Disabled after you have finished the installation.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 115 116

No comments

Nexcom VTC 6100 User Manual Page 64