Nexcom VTC 6100 User Manual download pdf (Page 53)

VTC 6100 User Manual

Chapter 3: System Setup

Removing the Chassis Cover

Front View

2. Lift the cover upward then remove it from the chassis.

Bottom View

Prior to removing the chassis cover, make sure the unit’s power is

off and disconnected from the power sources to prevent electric

shock or system damage.

1. The screws on the cover are used to secure the cover to the chassis.

Remove these screws and put them in a safe place for later use.

Rear View

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 115 116

Mobile Computing Solutions 1
Vehicle Telematics Computer 1
VTC 6100/VTC 6100-DK 1
User Manual 1
Contents 2
Declaration of Conformity 4
Copyright 4
Disclaimer 4
Acknowledgements 4
RoHS Compliance 6
Warranty and RMA 7
Safety Precautions 9
VTC 6100 User Manual 10
Headquarters 11
Package Contents 13
Ordering Information 15
Overview 16
Key Features 17
Hardware Specifications 17
Physical Features 21
Rear Panel 23
Mechanical Dimensions 27
Before You Begin 28
Precautions 28
ICEB 6100 30
Jumper Settings 31
Connectors 33
COM Express Row C and Row D 35
Connector location: J3 35
CompactFlash Connector 37
Connector location: J12 37
LVDS Connector + USB0 41
Connector location: CN3 41
LAN Connector 42
Connector size: RJ-45 42
Connector location: LAN1 42
USB Connector 42
Connector location: USB1 42
Connector location: USB2 43
LVDS Power Connector 43
Connector location: J5 43
Chapter 3: System Setup 53
Attach RF cable 55
RF cable mounted 56
Attach RF 58
CompactFlash 60
Installing the PCI-104 Module 62
Installing a SATA Hard Drive 64
Mounting stud 66
Head bolt screw 66
SATA connector 66
Power connector 66
Installing the SODIMM 68
Cable holder 70
Rackmount Brackets 71
Specifications 75
PCI Routing 79
Connector location: J1 82
CPU Fan Connector 84
Connector location: FAN1 84
PCIE 1X4 or PCIE 4X1 SWITCH 84
Jumpers and Connectors 86
Connector location: CN2 100
Line-out 101
PCI-104 VI/O Voltage Setting 101
Connector location: J13 101
Connector Pin Definition 102
MCU COM Port 103
Connector location: JP3 103
ACC_ON LED 103
Connector location: JP7 103
Temp Sensor 104
Connector location: JP8 104
DC Power Input Connector 104
Connector location: CN1 104
Power On and IDE Active LED 105
Connector location: LED1 105
GPIO and UMTS LEDs 105
Connector location: LED2 105
LED I/O Port Address and Data 105
Serial ATA 106
Connector location: CN6 106
Serial ATA Power Input 106
Connector location: J10 106
SIM Card Connector 108
Connector location: CN4 108
External Power Output Setting 109
Power-on Delay Setting 113
Power-off Delay Setting 114
Enable Power-off Delay 115
18hour 115
Appendix E: Power Consumption 116

Comments to this Manuals

No comments

Nexcom VTC 6100 User Manual Page 53

Comments to this Manuals

Related products and manuals for Hardware Nexcom VTC 6100